R2D2 Print

Printed out R2D2 last night.
Print Profile : n-vent mini medium settings from LulzBot.com with no adjustments.

Notes : Forgot to put down the PVA glue and had to spend some extra effort in getting on of the parts off. Print was pretty clean, some edges had a little curling near the top and I think it may be that the layer print time was to quick and did not allow the material to cool properly first.

Run time: ~4.5hrs

Cura Execution Output :

< Bed x: 0.00 y: 0.00 z: -1.36
< Bed x: 160.00 y: 0.00 z: -0.80
< Bed x: 160.00 y: 160.00 z: -0.80
< Bed x: 0.00 y: 160.00 z: -1.57
< Eqn coefficients: a: 0.00 b: -0.00 d: -1.41
< planeNormal x: -0.00 y: 0.00 z: 1.00
< Probing done!
< echo:endstops hit:  Z:-1.57
< < echo:Marlin1.0.0
< echo: Last Updated: Sep  4 2015 08:36:38 | Author: (Aleph Objects Inc, Mini-2015Q1)
< Compiled: Sep  4 2015
< echo: Free Memory: 4882  PlannerBufferBytes: 1296
< echo:Hardcoded Default Settings Loaded
< echo:Steps per unit:
< echo:  M92 X100.50 Y100.50 Z1600.00 E833.00
< echo:Maximum feedrates (mm/s):
< echo:  M203 X800.00 Y800.00 Z8.00 E40.00
< echo:Maximum Acceleration (mm/s2):
< echo:  M201 X9000 Y9000 Z100 E1000
< echo:Acceleration: S=acceleration, T=retract acceleration
< echo:  M204 S2000.00 T3000.00
< echo:Advanced variables: S=Min feedrate (mm/s), T=Min travel feedrate (mm/s), B=minimum segment time (ms), X=maximum XY jerk (mm/s),  Z=maximum Z jerk (mm/s),  E=maximum E jerk (mm/s)
< echo:  M205 S0.00 T0.00 B20000 X12.00 Z0.40 E10.00
< echo:Home offset (mm):
< echo:  M206 X0.00 Y0.00 Z0.00
< echo:PID settings:
< echo:   M301 P28.79 I1.91 D108.51